How To Tighten Awning Over Slide Out

Depending on the make and model there is a different method to adjust the tension.

How to tighten awning over slide out.

And i ve called and left a message still awaiting the return. Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them. You do not need to put the screws back in. Roller should now be free of mounting hardware.

If you are satisfied move on. Adjusting slide topper awnings is fairly simple. It s best to have three people for this job. Thanks for submitting your question on our ask an rv question page.

Just like that your awning is back in action. Two people will handle the awning arms one at each end while another one will feed the cord into your awning rail. In order to get the awning up and stable the tension needs to be adjusted to get the fabric taut. The awning over my slideout is sagging on one end but the other end is tight as both ends should be.

Different rv makers use different awning systems. If not then repeat the previous steps. Here is brad taylor showing how to adjust an awning fabric. How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.

Remove end cap or mount. Make sure it will not fall out. Usually takes 2 people. How do you tighten up slideout awnings that are sagging.

However perhaps someone here knows how to tighten the slide out awning. Many if not most slide toppers have only one spring which is probably the side that is tight. You ll be sitting cool in the shade. And rvs with slide outs a compartment that extends out from the main cabin providing extra living quarters are sometimes made with awnings over the slide out.

The awning over the big living room slide collects water because there is not enough tension to keep a constant slope. Dear jim well it depends on the size and make of your slide topper. If you over tighten the spring it will break. Roll the awning back up to observe how tight it is.

Put a cotter pin in the hole. Run slide in about 12. The slight slack allows water to puddle then as the puddle gets bigger. I had my slide out awnings installed by the dealer lakeshore rv.

Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total. Roll up topper on roller. Step 5 re install awning. Is there a way to adjust the tension on the end of the awning.

During regular use of your rv the awning fabric and slide in the awning tube causing alignment is.